351:, in particular, used "swing helpers", which meant the helper locomotives were placed mid-train at a point where they were pushing and pulling an approximately equal amount of tonnage, said location being referred to as the train's "swing point". This was also done to balance out the "slack" in the train between the locomotives, the swing helpers, and the end train helpers just in front of the caboose. However, this arrangement requires splitting the train in order to add or remove the helper engine(s), which can be a time-consuming maneuver. However, on some American railroads it was necessary to an extent, because operating rules required end of train helpers to be added at the end of the train, but in front of the
127:
364:
142:
272:
414:
38:
394:, in emergency situations, but in special cases trains are banked with uncoupled locomotives, which can be added or removed "in-flight." In the UK it was a usual practice for banking locomotives to follow and buffer-up to a slow-moving assisted freight train without coupling (as demonstrated in archive films of banking on the
232:
Pushers/helpers were commonly designed to provide extreme power for very short runs; as a result they could not push at full power for very far before steam pressure dropped. If it could push enough to get the train to the top of the grade, then it could build up pressure while coasting back down and
248:. A misunderstanding of signals by a pusher locomotive crew could result in a major wreck if the lead locomotive applied brakes while the bank engine was still applying power. The usual result was that the train would experience a violent run-in (an abrupt bunching of train slack), resulting in the
279:
Nowadays helpers/bankers are often controlled by coded radio signals from the locomotive at the head end of the train, allowing one engineer (driver) to simultaneously control the helper(s) and the train being helped. If radio operation is not possible, electrical control might be used, by way of
228:
were sometimes used in helper areas. Ordinary cabooses were built as lightly as practical and might be crushed by the helper/pusher's force, which could be as much as 90 tons. The heavy cabooses allowed crews to avoid the time-consuming procedure of splitting the train just ahead of the caboose.
220:
hose would not be coupled. When the train no longer required assistance, the helper/pusher would slow, then reverse and coast back down the grade to its siding at the bottom of the grade. This practice was outlawed in North
America after the end of the steam era.
280:
cables running the length of the train (especially in case of passenger trains). Alternatively, radio communication with the lead engine's driver facilitates manual operation, which is still the norm for bank engines at the end of freight trains in Europe.
398:) before applying more power, thus precluding the need for a standing start. Following an accident in 1969 this practice was discontinued. This procedure is not performed in North America, as it would violate Canadian and United States
336:), the limit is a train weight of 1400 tons; if a train is heavier, bank engines have to be added in the middle or to the end of the train in order not to exceed the maximum load for any coupler.
300:", "triple header", etc., depending on the number of helpers/bankers even when this lash-up of power was used for the entire run. These terms gradually fell out of general usage as
240:, each helper had to have a full crew on board. Careful coordination was required between engine crews to assure that all locomotives were operated in a consistent manner. Standard
161:'Big Bertha' providing banking at the rear of the train. In the present day, almost all trains can climb the incline unassisted, though heavier freight trains still require bankers.
196:
breaking away from the train and running back downhill. Also, in a pusher role, it was possible for the helper/banker to easily separate once the train had crested the
339:
Adding locomotives in the middle of the train has the distinct advantage of applying the helper power to only part of the train, thus limiting the maximum
320:
couplers are used, bank engines often cannot be added to the front of the train due to the limited strength of the couplers; In the case of standard
348:
503:"Report on the Collision that occurred on 18th May 1969 near Beattock in the Scottish Region British Railways :: The Railways Archive"
386:, they are usually added to the end of the train. Normally, they are coupled and the air hoses are connected, which is necessary for the
185:
on electric or diesel-electric locomotives, helpers/bankers can also be used to provide more braking force on long downhill gradients.
532:
288:
In the UK, an engine that was temporarily attached to the front of a train to assist with the ascent of an incline was called a
321:
296:
that powered the train to its destination. A train with one or more locomotives attached to the front may be described as a "
114:). Helpers/bankers are most commonly found in mountain divisions (called "helper districts" in the United States), where the
131:
126:
275:
Uncoupled banking service: BDe 4/4 multiple unit separating from the
Voralpenexpress after assisting on the 5 percent grade
188:
Bankers or helpers were historically positioned at the rear of the train, in which case they also protected against
118:
may demand the use of substantially greater motive power than that required for other grades within the division.
382:
To be able to add and remove helper locomotives quickly, which is especially important in Europe due to the high
146:
363:
216:. The locomotive would be brought up behind the last car of the train while the train was moving slowly. The
158:
41:
260:
193:
31:
181:
has eliminated the everyday need for bankers/helpers in all but a few locations. With the advent of
178:
141:
44:
259:, was named after these engines. It was where helper engines were kept to assist on the climb to
476:
399:
317:
205:
130:
1915 photo of a quadruple header (four front locomotives) train with a rear helper, climbing the
271:
430:
387:
301:
217:
174:
502:
30:"Pusher engine" redirects here. For aircraft that are pushed by the engines on the back, see
372:
368:
305:
237:
213:
166:
60:
383:
209:
103:
435:
413:
395:
297:
154:
150:
135:
52:
37:
526:
440:
241:
197:
182:
170:
107:
233:
while waiting for the next train to come along. This practice was common in Europe.
376:
340:
256:
115:
99:
344:
201:
189:
249:
173:, where significant grades are common and trains are long. The development of
91:
17:
418:
355:. This was done for the safety of the train crew riding inside the caboose.
56:
352:
325:
225:
88:
308:, and are not used for the common assemblage of several power units.
244:
were employed to tell the helper crew when to apply power, drift or
362:
343:
applied to the first car of the train to a safe level. The narrow
270:
245:
140:
125:
95:
48:
36:
333:
208:
and get ready for the next train. A common practice with
27:Locomotive used to assist trains up steep inclines
165:Helpers/bankers were most widely used during the
236:Since it was not possible to remotely control a
477:"Technical description by a Swiss train driver"
200:. Once separated, the banker would return to a
47:pushing a freight train on the grade between
8:
466:photo of reinforced outside braced caboose.
71:(United Kingdom/Australia) (colloquially a
462:NC&StL History & Steam Locomotives
212:was to remove the knuckle from the front
452:
349:Denver and Rio Grande Western Railroad
7:
367:Helper locomotives on the rear of a
324:couplers and a maximum grade of 28
292:. This differentiated it from the
25:
412:
63:is leading the train. July 2007.
132:Denver & Rio Grande Western
371:intermodal train entering the
1:
252:of part or all of the train.
224:Special heavily constructed
204:or stub so as to clear the
94:that temporarily assists a
549:
29:
533:Rail transport operations
507:www.railwaysarchive.co.uk
98:that requires additional
332:, for lines through the
159:MR 0-10-0 Lickey Banker
379:
276:
162:
138:
64:
366:
274:
144:
129:
87:(North America) is a
40:
179:electric locomotives
169:, especially in the
32:Pusher configuration
460:Prince, Richard E.
316:In countries where
419:Chapel-en-le-Frith
400:safety regulations
390:to work correctly
380:
328:(which is common,
302:diesel locomotives
277:
163:
139:
65:
431:Distributed power
318:buffers-and-chain
122:Historic practice
16:(Redirected from
540:
517:
516:
514:
513:
499:
493:
492:
490:
488:
473:
467:
465:
457:
417:
416:
373:Gallitzin Tunnel
369:Norfolk Southern
359:End of the train
347:portions of the
290:pilot locomotive
238:steam locomotive
210:knuckle couplers
145:1949 photo of a
21:
548:
547:
543:
542:
541:
539:
538:
537:
523:
522:
521:
520:
511:
509:
501:
500:
496:
486:
484:
475:
474:
470:
459:
458:
454:
449:
427:
411:
408:
384:traffic density
361:
314:
294:train engine(s)
286:
269:
267:Modern practice
242:whistle signals
175:diesel-electric
124:
35:
28:
23:
22:
15:
12:
11:
5:
546:
544:
536:
535:
525:
524:
519:
518:
494:
468:
451:
450:
448:
445:
444:
443:
438:
436:Double-heading
433:
426:
423:
422:
421:
407:
404:
396:Lickey Incline
360:
357:
313:
310:
285:
282:
268:
265:
261:Soldier Summit
183:dynamic brakes
155:Worcestershire
151:Lickey Incline
136:Soldier Summit
123:
120:
77:banking engine
53:Hrpelje-Kozina
26:
24:
14:
13:
10:
9:
6:
4:
3:
2:
545:
534:
531:
530:
528:
508:
504:
498:
495:
482:
481:lokifahrer.ch
478:
472:
469:
464:. p. 73.
463:
456:
453:
446:
442:
441:Station pilot
439:
437:
434:
432:
429:
428:
424:
420:
415:
410:
409:
405:
403:
401:
397:
393:
389:
385:
378:
374:
370:
365:
358:
356:
354:
350:
346:
342:
337:
335:
331:
327:
323:
319:
311:
309:
307:
303:
299:
298:double header
295:
291:
283:
281:
273:
266:
264:
262:
258:
253:
251:
247:
243:
239:
234:
230:
227:
222:
219:
215:
211:
207:
203:
199:
195:
191:
186:
184:
180:
176:
172:
171:American West
168:
160:
156:
152:
149:climbing the
148:
143:
137:
133:
128:
121:
119:
117:
113:
109:
105:
101:
97:
93:
90:
86:
85:pusher engine
82:
81:helper engine
78:
74:
70:
62:
58:
54:
50:
46:
43:
39:
33:
19:
18:Helper engine
510:. Retrieved
506:
497:
485:. Retrieved
480:
471:
461:
455:
391:
381:
377:Pennsylvania
341:drawbar pull
338:
329:
315:
293:
289:
287:
284:At the front
278:
257:Helper, Utah
255:The town of
254:
235:
231:
223:
187:
167:age of steam
164:
134:'s grade up
116:ruling grade
111:
84:
80:
76:
72:
68:
66:
61:SZ class 363
483:(in German)
306:steam power
106:to climb a
69:bank engine
512:2021-02-13
447:References
250:derailment
147:Black Five
92:locomotive
406:Accidents
388:air brake
312:Mid-train
304:replaced
218:air brake
527:Category
487:13 April
425:See also
226:cabooses
206:mainline
108:gradient
104:traction
57:Slovenia
353:caboose
214:coupler
194:coaches
89:railway
202:siding
190:wagons
73:banker
45:Taurus
345:gauge
246:brake
198:grade
157:with
100:power
96:train
59:. An
49:Koper
489:2018
392:e.g.
334:Alps
330:e.g.
112:bank
110:(or
51:and
375:in
322:UIC
192:or
177:or
153:in
102:or
83:or
75:),
55:in
529::
505:.
479:.
402:.
263:.
79:,
67:A
42:SZ
515:.
491:.
326:‰
34:.
20:)
Text is available under the Creative Commons Attribution-ShareAlike License. Additional terms may apply.
